Before using the Pulverizer machine, you must read the instruction manual carefully to understand its structure and circuit
The specific matters that should be paid attention to in use are as follows:
1. The electrical installation part should be done by a professional electrician as much as possible. And the main switch and control switch must be turned off during machine maintenance.
2. Do not let any part of your body enter the shredder until the main switch and control switch is turned off
3. Gloves must be worn when moving the Pulverizer machine knives. The Pulverizer machine knives are extremely sharp and can easily cause injury. When repairing the cutter of the Pulverizer machine, do not rotate the inertia wheel or the pulley, which will easily cut the operator.
4. Do not start the pulverizer until the hopper and screen frame are closed
5. If the travel switch that detects the closing of the feeding hopper is damaged, it must be repaired or replaced in time
6. Generally, the pulverizer machine that has passed the CE safety certification will have reminders or safety reminder labels attached to all parts of the machine. This part must be paid attention to.
If the Pulverizer machine gets stuck, unplug the Pulverizer machine under the sink, look for the drain holes, and if something is stuck in the wheel, remove it (never put your hand directly in it in the processor of the shredder). Then plug it back in again, turn on the switch, and it should be fine. If nothing gets stuck between the blades, you will need to use the Allen key that came with the Pulverizer machine.
SANWEI CRUSHING EQUIPMENT not only has Cyclone Collector but also Pulverizer Machine, welcome to visit our official website!